- UMC WAP is supported by two data transmission technologies: GPRS and CSD (GSM-data). You can configure your WAP settings as follows:
- Once you ordered the settings, you get an SMS with the configuration data for your phone. After you enter the parameters, a new profile with configuration data will appear in your profile list. Now your phone is ready for WAP! Do not forget to activate the service.
Configuring Your WAP via SMS
Configuring Your WAP Automatically
- Automatic configuration permits easier and faster set up of WAP service. In order to configure your phone, simply send an empty SMS to a number, which corresponds to your GSM model in the table below (usually, you can find the model indicated underneath the battery of your phone).
- You will get a reply with relevant configuration parameters to be saved in your phone
-
Manual Configuring
-
Below are the standard WAP settings. See your phone manual for detailed configuring instructions.
|
Parameter |
WAP CSD |
WAP GPRS |
| Connection name |
UMC WAP CSD |
UMC WAP GPRS |
| Bearer |
CSD (GSM Data) |
GPRS |
| Dial-up number |
950 |
- |
| Access Point Name |
- |
wap.umc.ua |
| User name |
leave empty |
leave empty |
| Prompt password |
No |
No |
| Password |
leave empty |
leave empty |
| Authentication type |
Normal |
Normal |
| IP address |
192.168.010.010 |
192.168.010.010 |
| Port number |
8080 – for phones with support WAP 2.0
9201 – for all other phones
|
| Data call type |
ISDN v.110 |
- |
| Homepage |
http://wap.umc.ua |
http://wap.umc.ua |
| Data speed |
9600 |
- |
| Connection security |
Off |
Off |
| Connection type |
Permanent |
Permanent |
|